Specifications

ManualsBrandsDNS ManualsAudio EquipmentTWS Earphone

Table Of Contents

2: C10-E

Multi-function

Button(MFB)

LED Indicator/Mic

Pogo Pins

LED Indicator

Model:

Bluetooth Version:V5.0

Range:≤10m

Earbud battery capacity:40mAh

Charging case battery capacity:300mAh

Charging time :1.5H

Playing time: About 4H

Weight: Earbud around 5g, Charging case around 46g

*NOTE* actual results may vary by device

3.The master earbud LED light flashes Red and White,

and the sub earbud LED light flashes White, the

earbuds enter pairing mode

1 Activating the EarBuds.

2.Take out the EarBuds from the case,they will

auto power on and pair with each other.

4.Search for “C10J"on mobile devices and tap to pair

it to both EarBuds

Insert the Earbuds into the charging case(Pogo pins

should be well-connected)

LED lights will be Red while charging. Once completely

charged the lights would turn off.

Tap 3 Times

Type-C charging port

Tap the multi-function button to pause the music

Tap the multi-function button to play the music

Specification

Tap the multi-fuction button for 3 times to activeate

the voice assistant

(eg.Siri)

WX-336A

Play the music

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions,may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for

help Changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority

to operate the equipment.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including

interference that may cause undesired operation.

Earphone

FCC ID: ZBCWX-336A

Summary of content (1 pages)

PAGE 1
Earphone 1 . Activating the EarBuds 2.Take out the EarBuds from the case,they will auto power on and pair with each other. 3.The master earbud LED light flashes Red and White, and the sub earbud LED light flashes White, the earbuds enter pairing mode 4.Search for “C10J"on mobile devices and tap to pair it to both EarBuds LED Indicator/Mic Insert the Earbuds into the charging case(Pogo pins should be well-connected) LED lights will be Red while charging. Once completely charged the lights would turn off.