GPS VEHICLE TRACKER USER MANUAL Preface Thank you for purchasing the TK103 GPS vehicle tracker. This manual shows how to operate the device smoothly and correctly. Make sure to read this manual carefully before using this product. Please note that specification and information are subject to changes without prior notice in this manual. Any change will be integrated in the latest release. The manufacturer assumes no responsibility for any errors or omissions in this document.
Content 1 Summary functions --------------------------------------------------------------------------------- 3 2 Application --------------------------------------------------------------------------------- 3 3 Hardware description 3.1 Front face -------------------------------------------------------------------------------------- 4 3.2 Rear face -------------------------------------------------------------------------------------- 4 3.
7 Faults & Solutions 8 Command ------------------------------------------------------------------------------------------------------------------------------------------- 11 12 1 Summary function Working Based on existing GSM/GPRS network and GPS satellites, this product can locate and monitor any remote targets by SMS or GPRS. 1.1 Positioning and Tracking: Through the on-line Positioning Platform or the cell phone to locates at times, and get the working status.
3.1 Front face 3.2 Rear face 3.3 Side face GSM/GPRS ANTENNA GPS ANTENNA INDICATOR FOR SIGNALS 3.4 Bottom face WIRE BOX PRESS BUTTON TO TAKE OUT SIM CARD. SIM CARD MICROPHONE 4 Specs.
Content Dim. Weight Network Band GPS chip GSM/GPRS module GPS sensitivity GPS accuracy Specs. 85mm x 63mm x 25mm(3.3”*2.5”*0.98”) 160g GSM/GPRS/GPS 850/1800/1900Mhz or 900/1800/1900Mhz or 850/900/1800/1900 SIRF3 chip Simcom300 or Simcom340 -159dBm 5m Time To First Fix Cold status 45s Warm status 35s Hot status 1s Work voltage Battery Standby Storage Temp. Operation Temp. Humidity 10V—36V Chargeable changeable 3.
5.2.1 Install Wire Box 5.2.
Installation steps (caution: the following installation should under no power, otherwise will be dangerous) Wire for cutting off oil of the tracker Yellow wire connects the relay feet 86; 85 feet to 12 V DC anode, 87 feet and 30 feet in series in the supply oil circuits. Wire for cutting off circuit of the tracker White wire connects relay feet 86; 85 feet to 12 V DC anode, 87 feet and 30 feet are in series in the supply power circuits.
5.5.2 you can Send "resumepassword" to the tracker, to restore the original setting in case of losing the new password. Remark: Please remember the new password, because most of the instruction need the password to set 5.6 Authorization There are only 5 numbers able to be authorized. 5.6.1 Call the tracker for 10 times, it will make the cell phone number as the authorized number automatically. 5.6.2 Send SMS "admin+password+space+cell phone number" to set up a authorized number.
5.9 Remote control oil and circuit 5.9.1 Control oil Send SMS "stopoil+password" to control oil. For example send SMS:stopoil123456 To supply the oil again, send SMS "supplyoil+password" to the unit. 5.9.2 Control circuit Send SMS "stopelec+password" to control circuit. For example send SMS: stopelec123456 To supply the circuit again, send SMS "supplyelec+password" to the unit. If there is no authorized number, all number can control.
"speed+080!+Geo-info" to the authorized numbers. It will alarm one time in each setting. 5.13.2 Cancel: Send SMS "nospeed+password" to deactivate the overspeed alert 5.14 Restart the tracker. Send SMS "reboot+password" to the tracker. For example"reboot123456".The tracker will be restarted. 5.15 SOS button Press the SOS for 3 second, it will send "help me ! " to all the authorized numbers every 3 minutes. It will stop sending such a SMS when any authorized number reply SMS "help me !" to the tracker. 5.
The IP address and port of Communication Protocol in the tracker can be modified and transferred data to other platform. Send SMS "ip +ip address+port +port number" to the unit. If the tracker’s IP address and port number should be modified to 116.255.131.50and 8500, send SMS "ip116.255.131.50port8500"to the tracker. 5.19.2 Set APN/APN user and password 19.2.1 In order to send GPS data to IP address, you still must set mobile network APN (.
Location report in Don’t use it in the place beyond reach of signals. Place the unit outdoors, especially when starting it up. digits of zeros. 8 Command N o 1 FUNCTION SMS SMSREPLY CHAP Intialition begin123456 begin ok Change password password123456 666888 Change password ok 5.5.1 Resume password resumepassword resume password,passwor d is 123456 5.5.2 Add in number admin123456 13511113333 admin ok 5.6.2 Delete noadmin123456 13511113333 no admin ok 5.6.
Remark: 1.123456 is the deivce password, 1351111333 is the authorized number,, 13500001111 is the the device terminal track number 2.The first using ,please put the device to the outdoor which have the power GPS signal ,then begin to track after two minitues. 3.The English capital letter and lower-case represent the command , English capital letter is the setting content ,please using lower –case to edit all commands by telephone.
