Installation Manual

BINDER
POSTS
BINDER
POSTS
SPRING
DRIVER
SCREW
DRIVER
SCREW
DRIVER
SCREW
DRIVER
SCREW
LABEL
DRIVER SCREW
DRIVER PLATE
KEEPER
DRIVE PLATE
DRIVE EARS
PADDLE ASSY.
SCREW &
LOCKWASHER
ESCUTCHEON
ASSY.
SET SCREWS
LATCH
CUTOUT
CYLINDER
.265 DIA
(6,73)
(2) HOLES
CAM DISC
1.25 HOLE
(31,75)
SET SCREW
PIVOT PIN
www.adamsrite.com
Phone: [phone]
800-872-3267
Fax: [phone]
800-232-7329
Page 1 of 2
(CAUTION: DO NOT OVERTIGHTEN NUT)
LHRLHRHRRH
INSIDE
OUTSIDE
TOP
5.REPLACE KEEPERS.
6.CONFIGURE CAM DISC.
(SEE REVERSE)
4.REMOVE DRIVER SCREW IF NECESSARY,
AND PLACE IN DESIRED LOCATION.
3.REVERSE SPRINGS & DRIVER
PLATE IF NECESSARY.
2.REMOVE KEEPERS TO SEE LOCATION
OF SPRINGS & DRIVER PLATE.
SEE REVERSE FOR CAM DISC ASSY.
1.FIND DESIRED CONFIGURATION.
INSTRUCTIONS FOR CHANGING HAND
STEP 4
STEP 3STEP 2
STEP 1
1.PREPARE STILE AS SHOWN.
2.INSERT BINDER POST THRU .265 DIA. HOLE
IN STILE.
3.SECURE BINDER POST WITH 1/4-28 NUT.
1.INSTALL 4500, 4700 AND 4900 SERIES
DEADLATCH PER MOUNTING INSTRUCTIONS.
2.INSTALL 4580 CAM DISC ASSY.
SECURE WITH SETSCREW.
4580
BACKSET OF
DEADLATCH
C
L
(76,20)
3.000
(43,64)
1.718
L
C
INSTALLATION
1.INSTALL ESCUTCHEON ASSY.
2.USING 8-32 SCREWS W/LOCKWASHER,
SECURE ESCUTCHEON ASSY. TO
BINDER POST.
IMPORTANT,
TIGHTEN THESE SCREWS SECURELY.
1.INSTALL PADDLE ASSY. ALIGN DRIVE EARS
ON PADDLE WITH SLOT IN DRIVE PLATE.
2.INSTALL PIVOT PIN.
3.INSTALL PIVOT PIN SET SCREW. TIGHTEN
SET SCREW FLUSH WITH BOTTOM OF
ESCUTCHEON.
+1/32
-0
+0,79
-0
PULL TO LEFT PUSH TO RIGHTPULL TO RIGHT PUSH TO LEFT
80-0180-200
4590 PADDLE OPERATOR
Rev.
Appvd: MP
Ecn 11955A
Date: 06-19-12
Date: 06-19-12
E