Use and Care Manual

ManualsBrandsDoberman Security ManualsElectricalHome Security Wireless Door Alarm with Remote

SE-0119 WIRELESS DOOR ALARM W/REMOTE

Magnetically Triggered Door Alarm and Remote Control

PACKAGE INCLUDES:

y Main Unit ... 1PC

y Magnetic Sensor ... 1PC

y Remote Control ... 1PC

INSTALLATION:

y Simply peel and stick the alarm to the door or any other place you wish to protect.

y For best performance, keep the distance between the Main Unit and Magnetic Sensor

no wider than half an inch.

y The Magnetic Sensor can be installed on either side of the Main Unit. (see drawing

below)

BATTERY INSTALLATION/ REPLACEMENT:

Main Unit:

y Set the switch to OFF and slide down the battery cover.

y Follow the polarity instructions to insert 3 AAA Alkaline batteries (not included).

y Put the battery cover back on.

Remote Control:

y Unscrew the back cover to insert or replace 1 fresh CR2032 battery. Follow the

polarity instructions.

y Press any button on the remote Control. The red LED will light if the battery is installed

correctly.

OPERATION:

Remote Mode:

y Make sure the Magnetic Sensors are aligned and batteries are installed correctly.

y After installing the batteries, slide the switch to , and the red LED will flash once.

y Slide down the battery cover and press the small button above the battery

compartment once. A beep will sound, and the red LED will flash for 5 seconds.

y While the LED is still flashing, press any button on the Remote Control and you’ll

hear 2 Beeps. This indicates the code has been learned successfully.

y After the code has been learned, wait 5 seconds, then press and hold the ON button

on the Remote Control. A Beep will sound, and the Main Unit will be armed within

three seconds. The red LED will flash three times indicating is has been armed.

y Press the OFF button on the Remote Control, a Beep will sound, accompanied by a

flashing red LED. The device is now disarmed.

y Under ARM status, once the door is opened, the alarm will go off continuously for 30

seconds.

y Turn off the alarm by pressing the OFF button on the Remote Control or slide the

switch to OFF on the Main Unit.

Manual Mode:

y Make sure the Magnetic Sensors are aligned and that the batteries are installed

correctly.

y Slide the switch to

, and the Main Unit will be armed in three seconds and the red

LED will flash three times.

y Once the door is opened, the alarm will go off continuously for 30 seconds.

y Turn off the alarm by sliding the switch to OFF.

Summary of content (6 pages)

PAGE 1
SE-0119 WIRELESS DOOR ALARM W/REMOTE Magnetically Triggered Door Alarm and Remote Control PACKAGE INCLUDES: y Main Unit ... 1PC y Magnetic Sensor ... 1PC y Remote Control ... 1PC INSTALLATION: y Simply peel and stick the alarm to the door or any other place you wish to protect. y For best performance, keep the distance between the Main Unit and Magnetic Sensor no wider than half an inch. y The Magnetic Sensor can be installed on either side of the Main Unit.
PAGE 2
NOTES: y y y y y To ensure proper performance, check the battery power periodically. Not certified for use as a pool alarm. Please allow 5 seconds for the remote control to engage after switching the unit from manual mode to remote mode. The Magnetic Sensor can be installed on either side of the Main Unit, to allow for doors that open from the left or the right.
PAGE 3
THERE ARE NO EXPRESS WARRANTIES EXCEPT AS LISTED UNDER “LIMITED WARRANTY COVERAGE”. DOBERMAN IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT, OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING WITHOUT LIMITATION, LOSS OF GOODWILL, PROFITS OR REVENUE, LOSS OF USE OF THIS PRODUCT OR ANY ASSOCIATED EQUIPMENT, COST OF SUBSTITUTE EQUIPMENT, DOWNTIME COSTS, OR CLAIMS OF ANY PARTY DEALING WITH BUYER FOR SUCH DAMAGES.
PAGE 4
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 5
Presiona cualquier botón del control remoto, escucharas otro ruido, eso indica que el código se aprendió con éxito. y Oprime el “On” botón del control remoto, otro ruido se escuchara, y la unidad principal estará armada en tres segundos. La luz roja se enciendara tres veces. y Presiona el “Off” botón del control remoto, otro ruido se escuchara acompañado con una luz roja. El mecanismo ahora está desarmada.
PAGE 6
GARANTÍA LIMITADA EXCLUSIONES Y LIMITES: La garantía es valida solamente en defectos materiales o de fabrica, y no cubre uso normal o daño cosméticos.