User manual

41
5. Operating
5.1 Initial commissioning
• Screw out the battery tailstock
after unpacking.
• Remove the insulating spacer
in the battery compartment.
• Screw the battery tailstock
tightly again.
• Charge the battery completely.
5.2 Inserting battery
Rigiet is designed for use with replaceable battery. To ensure a correct
installation, the battery must be used as indicated in the following steps:
1. Screw out the battery case cap.
2. Insert the battery into the handle
according to its correct placement
direction.
3. Screw in and tighten the battery case
cap.
+ -
5.3 Inserting the phone
Material damage
• If your smartphone has a protective cover
remove it before attaching the smartphone
to Rigiet.
• Do not start Rigiet to the stabilization
before the phone is inserted correctly.
1. Turn on the phone holder adjustment scroll to loosen the
phone holder to a width that enables phone insertion.
2. Insert the smartphone in a way that it is close to the engine,
and fix it by turning the phone holder adjustment scroll.
5. Operating