User Guide
Table Of Contents
- 1. Security Precautions
- 2. Introduction
- 3. Hardware Installation
- 4. Electrical Specifications
- 5. Installation and Commissioning
- 5.1 Installing Software
- 5.2 Connecting Power Supply
- 5.3 Connecting Emergency Stop Switch
- 5.4 Connecting External Cables
- 5.5 System Commissioning
- 6. Operation
- 7. Maintenance
Dobot M1 User Guide 6 Operation
Issue V1.0.4 (2018-08-30) User Guide Copyright © Yuejiang Technology Co., Ltd
73
During switching, the green LED indicator will keep on. After completion, the
green LED indictor will be blinking and Current Mode is changed to 3D
Printing Mode, as shown in Figure 6.21.
Figure 6.21 Complete 3D printing switching
Select Machine > settings on the Cura page.
The Machine settings page is displayed.
Set the corresponding parameters on the Machine settings and click OK, as
shown in Figure 6.22. Table 6.8 lists the values of the parameters that need to
be set. The other parameters are set by default.
Figure 6.22 Parameters setting
Table 6.8 3D printing parameters description
Parameter
Description
Maximum width
The maximum width
please set to 80mm
Maximum depth
The maximum with
please set to 80mm
Maximum height
The maximum height