Manual

Conveyor Belt User Guide 4Position Adjustment
Issue V1（2019-03-26） User Guide Copyright © Yuejiang Technology Co., Ltd.
9
 Adjusting the Placing Position
1. Select SuctionCup to pick up the blocks, and then press and hold down the Unlock
button to move the Dobot 1 to make the blocks on the conveyor belt. As shown in
Figure 4.3.
Figure 4.3 Adjust Placing position
2. Unselect SuctionCup to put down blocks on the conveyor belt. The operation panel
on the DobotStudio will record the values of X, Y, Z axes automatically, and write
the values of the X, Y, Z axes in the picking demo as shown in Figure 4.4.
Figure 4.4 Modify the placing position
 Adjusting the stopping position
Control the conveyor belt move a distance by setting the speed and time in the picking demo
to make these blocks in a position where is in the workspace of the Dobot 2.