Manual
Table Of Contents
- 1. Specifications
- 2. Installation Instructions
- 3. Modbus-RTU Control
- 3.1 Wiring
- 3.2 Default communication parameters
- 3.3 Modbus-RTU description
- 3.3.1 RTU framing
- 3.3.2 Supported Modbus function code
- 3.3.3 Register mapping
- 3.3.4 Register description
- 3.3.4.1 Initialization
- 3.3.4.2 Force
- 3.3.4.3 Position
- 3.3.4.4 Speed
- 3.3.4.5 Initialization state
- 3.3.4.6 Gripper state
- 3.3.4.7 Current position
- 3.3.4.8 Save parameter
- 3.3.4.9 Initialization direction
- 3.3.4.10 Slave address
- 3.3.4.11 Baud rate
- 3.3.4.12 Stop bits
- 3.3.4.13 Parity
- 3.3.4.14 Test I/O parameters
- 3.3.4.15 I/O mode switch
- 3.3.4.16 I/O parameter configuration
- 4. I/O Control
PGE-2 Gripper User Manual
Issue V1.0 (2021-07-30) User Manual Copyright © Yuejiang Technology Co., Ltd.
25
Save settings
Save the configured parameters, and write 01 at the register of 0x300 for saving.
Send: 01 06 03 00 01 48 4e
Return: 01 06 03 00 01 48 4e
Restart
After power off, you can connect the input and output to the corresponding equipment, and
power on after confirming that the wiring is correct. The gripper will be initialized
automatically. Then the gripper is controlled according to the input signal, and the running state
is feed back through output.