Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 2 Quick Start
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
6
macOS 10.10, macOS 10.11, and macOS 10.12
Obtaining the DobotStudio Package
Before using Dobot Magician, download the Windows DobotStudio package from
https://www.dobot.cc/downloadcenter.html. The macOS version is also downloadable in this URL.
Installing the DobotStudio
Prerequisites
The DobotStudio package has been obtained.
Procedure
Unpack the DobotStudio package to a destination directory.
For example, this directory is Installation Directory\DobotStudio. You can install
the DobotStudio to another location based on site requirements.
In the installation directory double-click DobotStudioSetup.exe. The Select Setup
Language dialog box is displayed, as shown in Figure 2.4.
Figure 2.4 The Select Setup Language dialog box
Figure 2.5 Select English
During the installation, the Driver Installation dialog box is displayed, , two drivers
needs to be installed, as shown in Figure 2.6.