Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
107
Figure 5.125 Place filament and extruder to the Filament holder
Operating Repetier Host
Repeiter Host has been built into DobotStudio. After burning 3D printing firmware, the
Repetier Host page will be displayed automatically.
Prerequisites
The 3D printing model has been prepared.
The printing platform has been prepared and please place it in the workspace of the
Dobot Magician.
Dobot Magician has been powered on.
Dobot Magician has been connected to DobotStudio successfully (Only USB
connection is supported).
The 3D printing kit has been installed.
5.9.2.1 Burning Firmware
Procedure
The 3D Printing FM page is displayed, as shown in Figure 5.126.