Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
114
Before printing, you need to test the extruder to check whether the melted filament
flows from the nozzle of the extruder.
The temperature of the extruder should be above 170℃. Dobot Magician will not
start 3D printing until the filament is in the melting state. So you need to heat the
extruder first.
Set the heating temperature to 200℃ on the Manual Control tab of the Repetier
Host page and click , as shown in Figure 5.134.
DANGER
The heating rod will produce high temperature up to 250℃, please be careful. Do not let
children play with it alone. The process needs to be monitored when it is running. After
the process is completed, please turn off the equipment promptly.
Figure 5.134 Heat the extruder
Click the extruder feeder when the heating temperature is up to 200℃ and feed
up to10mm-30mm, as shown in Figure 5.135.