Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
119
Figure 5.141 Slic3r page
Set the slicing parameters on the Slic3r page.
The 3D printing effect depends on the slice parameters. This topic provides a
configuration sample, you can select File > Load Config on the Slic3r page to
import it directly for printing.
The path of the configuration sample is Installation
directory\DobotStudio\attachment, as shown in Figure 5.142.
Figure 5.142 Configuration sample
Dobot-2.0-Vase.ini is used for printing a thin-walled vase, while Dobot-2.0-ini