Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
122
Operating Cura
If you need to use Cura software for 3D printing, please launch the Cura software after burning
firmware.
Prerequisites
Slice software Cura has been installed.
The download path is https://ultimaker.com/en/products/ultimaker-cura-software/list.
Please download the recommended version V14.07. The way how to install and use is not
descripted in this topic.
The 3D printing model has been prepared.
The printing platform has been prepared and please place it in the workspace of
Dobot Magician.
Dobot Magician has been powered on.
Dobot Magician has been connected to DobotStudio successfully (Only USB connection
is supported).
The 3D printing kit has been installed.
5.9.3.1 Burning Firmware
Procedure
The 3D Printing FM page is displayed, as shown in Figure 5.147.
Figure 5.147 Burn firmware