Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 2 Quick Start
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
8
Figure 2.8 The Completing the DobotStudio Setup Wizard dialog box
Click Finish.
Verifying the Installation
2.2.4.1 Verifying the DobotStudio
If the DobotStudio is launched and runs properly by double-clicking the desktop shortcut to
this program, it means that it is installed successfully.
2.2.4.2 Verifying the Dobot Magician Driver
If an available COM port is displayed on the upper left corner of the DobotStudio page after
the robotic arm is powered on, as shown in Figure 2.9, the Dobot Magician driver is installed
successfully.
Figure 2.9 An available COM port is displayed
If no COM port is available, check whether the robotic arm driver is successfully installed by
following the steps below.