Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
126
The printing window is displayed and the current printing temperature is shown
on the top corner of the window, as shown in Figure 5.152.
Figure 5.152 Printing window
Set Temperature to 200 and press down Enter to heat the extruder.
The temperature of the extruder should be above 170℃. Dobot Maigicain will
not start 3D printing until the filament is in the melting state. So you need to
heat the extruder first.
DANGER
The heating rod will produce high temperature up to 250℃, please be careful. Do not let
children play with it alone. The process needs to be monitored when it is running. After
the process is completed, please turn off the equipment promptly.
Before printing, you need to test the extruder to check whether the melted filament
flows from the nozzle of the extruder.
Click the feedstock extruder or click the given stepper, such as 10, 1, 0.1 (10 is
recommended) on the Operational page and feed up to 10mm-30mm, as shown in
Figure 5.153.