Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
127
Figure 5.153 Click feedstock extruder
If the melted filament flows from the nozzle of the extruder, the extruder is working
properly.
NOTICE
If the filament extrusion is in the opposite direction, please remove the filament, and turn
the extruder around, then re-push down the filament.
NOTE
During printing, if the distance from Dobot Magician to the printing platform is too large
or too small to paste the first layer, it can lead to the nozzle blockage. For increasing the
stickiness of the first layer, placing a masking paper on the platform is recommende.
Press the Unlock key on the Forearm and drag Dobot Magician to make the
printing head contact the surface of the masking paper(The distance between the
printing head and the surface of the masking paper is the thickness of a sheet of
A4 paper), then release the Unlock key.
Input command M415 on the lower right of the Operational page to get the
current coordinates, as shown in Figure 5.154.
Also, you can press the Key button on the bace of the base to get the current
coordinates.