Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
129
Figure 5.155 Location of Dobot Magician
This step is used for observing the nib position on the calibration board when moving
J1-axis in Step 5, to improve calibration accuracy.
Click Teaching&Playback on the DobotStudio page.
The Teaching&Playback page is displayed.
Press the Unlock key on the Forearm and drag Dobot Magician to make the nib
contact the surface of the calibration board, then release the Unlock key.
The coordinates of this point will be displayed on the Teaching&Playback
page.
Select this point and right-click SetHome, as shown in Figure 5.156.
Figure 5.156 Set homing position