Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
143
Also, the homing point can be use-defined, you can select a saved point on the
Teachong&Playback page and right-click SetHome to set this saved point as the homing point, as
shown in Figure 5.175.
Figure 5.175 Set homing point
Connecting with WIFI Kit
You can connect Dobot Magician to a PC via WIFI kit without USB cable, making Dobot
Magician and PC in the same WLAN. Figure 5.176 shows the WIFI kit.
Figure 5.176 WIFI kit
Prerequisites
Dobot Magician has been connected to a PC via USB cable.
Dobot Magician has been connected to the power adapter.