Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
144
The WIFI name and password have been obtained and must be the same as that of
PC.
Procedure
Figure 5.177 Connect with WIFI kit
NOTICE
Please turn off the Dobot Magician completely first before connecting or disconnecting
external equipment. Or, it causes serious damage to your device
After turning on, there are two short beep sounds and the blue LED indicator on the
WIFI module is on.
The Set Dobot Wi-Fi page is displayed.
If you unselect Dynamic Host Configuration Protocol (DHCP), you need to set IP
address, Netmask, Gateway. For details, please see Table 5.17.