Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
145
Figure 5.178 Set WIFI
Table 5.17 Parameter description
Parameter
Description
SSID
Set WIFI name
The WIFI name and password have been obtained and must be the same as
that of PC
Password
Set WIFI password
Dynamic Host Configuration
Protocol (DHCP)
Whether to select DHCP
Yes: Only set SSID and Password
No: Only set IPAddress, Netmask and Gateway
IPAddress
Set the IP address of Dobot Magician. The IP address of Dobot Magician and
the PC must be in the same WLAN without conflict.
Netmask
Set subnet mask
Gateway
Set gateway
DNS
Set DNS