Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 2 Quick Start
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
11
Figure 2.13 The gesture of Dobot Magician before power-on
Power off: When the LED indicator is green, press down the power button to turn
off the robotic arm. In this case, the Forearm moves slowly to the Rear Arm while
the angle between them becomes small. Finally, the two arms reach a specific
position.
WARNING
During the shutdown process, watch your hand.
Getting Started
This topic describes how to use the Dobot Magician to complete the teaching & playback
function by saving three points in the MOVJ mode, allowing you to get the basic knowledge of the
usage of the robotic arm.
Prerequisites
The DobotStudio has been installed. For details, see 2.2 Installing the DobotStudio.
The Dobot Magician is powered on. For details, see 2.3 Powering On/Off the Dobot
Magician.
Procedure
The DobotStudio page with its beginner guide is displayed, as shown in Figure 2.14.