Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
160
Figure 5.196 Connect sliding rail and wire set
Sliding Rail Parameter Description
Table 5.21 Sliding rail parameter description
Parameter
Description
Maximum payload
5kg
Maximum Distance
1000mm
Maximum speed
150mm/s
Maximum acceleration
150mm/s
2
Repeated positioning accuracy
0.01mm
Absolute positioning accuracy
0.25mm
Demo Description
This topic describes how to use the V2 version of sliding rail for writing.
Prerequisites
The sliding rail has been installed and connected to the Dobot Magician.
Dobot Magician has been powered on.
Dobot Magician has been connected to DobotStudio successfully.
The writing and drawing kit has been installed. For details, please see 5.4.1 Installing