Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
166
Figure 5.205 Select end-effector
NOTICE
Normally, If SuctionCup or Gripper is selected from the end-effector drop-down list
after the air pump has been connected, the air pump will be controlled by the system. In
this topic, we use I/O interfaces to control the air pump, so SuctionCup and Gripper
cannot be selected, to avoid conflict.
Figure 5.206 Switch advanced function
“The saved point is displayed on the Teaching&Playback page, as shown in Figure
5.207.
NOTE
If the intake is not obvious, please modify PauseTime of this saved point.