Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
171
Appendix A Dobot Magician Homing Operation
Homing Procedure
：
1. Turn on Dobot Maigcian, wait for about 20 seconds after green light is on, and then click
Home on Dobot Studio page to make Dobot Magician execute homing operation.
2. Blue light will flash during homing, and Dobot Magician will execute homing operation.
Do not operate the Dobot until the green light is on.
3. Save points and download them to Dobot Magician. Click OK to wait downloading
finished.
Figure 5.214 homing tip
4. Disconnect USB cable and press down Key button to execute offline mode.
Playback Procedure
：
If there are some points saved in Dobot Magician before, you can turn on Dobot Maigican
directly, wait for about 20 seconds after green light is on, press down Key button for long time
to execute homing operation, and then press down Key button again to execute offline mode.