Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 2 Quick Start
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
13
Figure 2.16 The Question dialog box
Because this section is for quick access to the Dobot Magician only and no high
accuracy is required.
When Connect changes to Disconnect, it means that the DobotStudio is connected
to the Dobot Magician, as shown in Figure 2.17.
NOTE
To achieve a high accuracy of the robotic arm, click Wait Link.
Figure 2.17 The DobotStudio is connected to the Dobot Magician
1. Click Teaching & Playback, as shown in Figure 2.18.