Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
42
Figure 5.14 The effect of the gripper kit installation
Teaching & Playback Page
The Teaching & Playback page is shown in Figure 5.15. To access it, select Connect >
Teaching & Playback on the DobotStudio page.
Figure 5.15 The Teaching & Playback page
In both Easy and Pro modes, you can switch between Easy and Pro modes, set loop,
speed percentage, and acceleration percentage, as shown in Figure 5.16.
Figure 5.16 Set Easy/Pro, Loop, Speed and Acceleration (Acc)