Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
54
Figure 5.32 Move the small cube in the JUMP motion mode
Working in Offline Mode
Offline mode allows the Dobot Magician to perform the points in the Save points list previously
downloaded from the DobotStudio without keeping the USB connection established.
Prerequisites
The Dobot Magician has been powered on.
The Dobot Magician has been connected to the DobotStudio.
The points have been saved.
Procedure
The Question dialog box is displayed, asking if you want the Dobot Magician to
automatically to go back to its homing point before performing the save points in the
offline mode, as shown in Figure 5.33.