Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
71
Click OK, as shown in Figure 5.63.
The Dobot firmware upgrade window is displayed.
Figure 5.63 Confirm the firmware upgrade
Click Confirm to upgrade the Dobot firmware, as shown in Figure 5.64. When
the upgrade process bar shows 100% and a short beep sound is heard, it means
that the firmware is upgraded successfully, as shown in Figure 5.65. In this case,
the LED indicator turns from red to green. Then click Complete to exit.
Figure 5.64 Click Confirm