Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
74
cannot engrave on an object. In this case, the image is highlighted with a red border, as
shown in Figure 5.70.
Figure 5.69 The PLT or SVG image is located within the annular area
Figure 5.70 The PLT or SVG image is located outside the annular area
Click Open on the Write & Draw page to import a built-in PLT or SVG image file from
the DobotStudio installation directory
InstallatonDirectory\DobotStudio\config\prefab\system\source, as shown in Figure
5.71. You can also import your custom PLT or SVG image file.