Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
77
Figure 5.75 Convert Bitmap to SVG
Click Setting on the Write & Draw page, as shown in Figure 5.76.
Figure 5.76 Click Setting
Click Write & Draw to set the Dobot Magician’s Velocity (mm/s), junction
velocity (JunctionVel: mm/s), PlanAcc (mm/s
2
), acceleration (Acc: mm/s
2
),
PenUpOffset (mm), PenDown (mm), as shown in Figure 5.77.
NOTE
We recommend to set the Velocity in the range of 0mm/s to 500mm/s and to adjust the
acceleration between 0mm/s
2
and 500mm/s
2
.