Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
79
Figure 5.79 Turn on the laser
Danger
When using a laser, wear lasing protective eyeglass.
Never aim the laser at a person’s eye and clothes or stare at the laser from
within the beam.
In the central laser focus, a high temperature heat is created and can burn
materials such as papers and wooden boards.
Never aim the laser at a person and their clothes.
Do not allow the children to play with the Dobot Magician. Monitor the robotic
arm while it is running and power off it once the movement is complete.
Figure 5.80 Unselect the Laser
NOTICE
If you cannot set the laser to be at its minimum focus, it’s probably because the focal
length is long. To shorten the focal length, slightly turn the sliver lens screw (as
shown in Figure 5.81) on the bottom of the laser kit.