Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
80
Figure 5.81 Adjust the laser focus
The point marked by a red box, as shown in Figure 5.82, corresponds to the position
of the end-effector of the Dobot Magician. This point changes its position only within
the annular area when the robotic arm moves.
Figure 5.82 The point corresponding to the end-effector of the robotic arm
Once this step is complete, the next time you start to engrave, directly import a PLT
or SVG image file without adjusting the position of the laser kit, and click SyncPos,
and then click Start to start engraving on the paper, as shown in Figure 5.83.