Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
83
Figure 5.86 The process of engraving a grayscale image
Installing a Grayscale-engraving Kit
Both grayscale-engraving and laser-engraving use the laser kit as the end-effector. For the
installation method, see 5.5.1 Installing a Laser Kit.
Connecting the DobotStudio
If the current firmware of the Dobot Magician is the 3D Printing firmware instead of
the Dobot firmware, the Select tool dialog box is displayed, asking if you want to
switch to the Dobot firmware. In this case, perform the following steps to switch to
this firmware.
Select DobotStudio to upgrade the Dobot firmware, as shown in Figure 5.87.
The Question dialog box is displayed.