Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
86
Figure 5.91 Click LaserEngraving
Importing Image Files and Setting Engraving Parameters
Prerequisites
An image file has been created. You can also import system image, the importing path is
Installation Directory\DobotStudio\attachment\grbrMode\source.
Procedure
NOTICE
The imported image should be placed within the annular area on the LaserEngraving
page, as shown in Figure 5.92. If not, the robotic arm reaches its limited position and thus
cannot engrave on an object. In this case, the image is highlighted with a red border, as
shown in Figure 5.93.