Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
89
Table 5.11 Laser engraving parameters
Items
Description
Grayscale range
Set the grayscale range
Range: 0 - 255
Default value: 20 - 240
Laser power range
Set the laser power range
Range: 2 - 100
Default value: 20 - 90
Border
Set the border width.
Unit: pixel
Range: 0 - 50
Default value: 4
Click Setting on the LaserEngraving page.
Set the JunctionVel (junction velocity), PlanAcc (linear acceleration), and Acc
(acceleration), for example, set all to 5, as shown in Figure 5.98.
Figure 5.98 Set the parameters of laser engraving
Adjust the Laser Focus and Start to Engrave