Manual
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
- 5.1 Introduction to the DobotStudio
- 5.2 Performing Teaching & Playback Tasks
- 5.3 Working in Offline Mode
- 5.4 Writing and Drawing
- 5.5 Performing Laser Engraving Tasks
- 5.6 Engraving a Grayscale Image
- 5.7 Controlling with your Hand Gesture
- 5.8 Controlling with your Mouse
- 5.9 Operating 3D Printing
- 5.10 Calibration
- 5.11 Connecting with WIFI Kit
- 5.12 Connecting with Bluetooth Kit
- 5.13 Operating Blockly
- 5.14 Scripting
- 5.15 Operating Stick Controller Kit
- 5.16 Operating Sliding Rail
- 5.17 Multiplexed I/O Demo
- Appendix A Dobot Magician Homing Operation
Dobot Magician User Guide 5 Operation
Issue V1.7.0 (2019-01-09) User Guide Copyright © Yuejiang Technology Co., Ltd.
90
Danger
When using a laser, wear lasing protective eyeglass.
Never aim the laser at a person’s eye and clothes or stare at the laser from
within the beam.
In the central laser focus, a high-temperature heat is created and can burn
materials such as papers and wooden boards.
Never aim the laser at a person and their clothes.
Do not allow the children to play with the Dobot Magician. Monitor the robotic
arm while it is running and power off it once the movement is complete.
Figure 5.99 Select the Laser
Press and hold the unlock button on the Forearm to move the robotic arm to
raise and lower the height of the laser kit until the laser is the brightest with a smallest
possible spot size. When the laser power level is high enough, the laser beam can
burn and cut the paper. After getting a pretty good focus, unselect Laser on the
Operation Panel page to turn off the laser, as shown in Figure 5.100.