User's Guide
Table Of Contents
- 1. Security Precautions
- 2. Quick Start
- 3. Introduction
- 4. Interface Description
- 5. Operation
Dobot Magician Lite User Guide 5 Operation
Issue V1.0.0 (2019-12-04) User Guide Copyright © Yuejiang Technology Co., Ltd.
65
Figure 5.53 Lock the height of writing
NOTE
The value of the Z axis is the PenDown parameter. This parameter can be set by selecting
Setting > Write Draw > PenDown on the Write & Draw page, as shown in Figure 5.54.
If the effect of writing is not satisfactory, slightly raise and lower the height of the writing
and drawing kit or directly change the value of PenDown.
Figure 5.54 The PenDown parameter
Magician Lite automatically moves above the position (PenDown) of the start point