User Manual

08
4.Rigiet Guide to use
4.2First Use after Unpacking
4.3Inserting battery
4.4Inserting phone
The Rigiet is designed with a replaceable battery. To ensure a correct
installation, users shall install the battery by referring to the following steps:
! Do not start Rigiet to the stabilization state before the phone is inserted
correctly;
After unpacking, screw out the
battery tailstock, remove the
insulating spacer in the battery
compartment, and then screw in
and tighten the battery tailstock.
1.Screw out the battery case cap;
2.Insert the battery into the handle according
to its correct placement direction;
3.Screw in and tighten the battery case cap.
1.Turn the phone holder adjustment scroll to loosen the phone holder to a
width that enables phone insertion.
Tightening
Loosening
2.Insert the phone in such a manner that it is close to the motor, and turn
the phone holder adjustment scroll to clamp the phone.
Tightening
+Positive
electrode
-Negative
electrode