User Manual

09
4.Rigiet Guide to use
4.5Balancing your Rigiet
！Please do not turn on Rigiet to a stabilization state until it is balanced.
When the center of gravity of the roll motor is slightly biased, the motor can
work normally; while when heavily biased, the stabilization performance
and the endurance time will be decreased:
1.Loosen the balancing screw; hold and move the balancing arm according
to the sliding direction, and then tighten the balancing screw;
2.Observe whether the Rigiet can be stationarily kept in a balanced position;
3.If yes, the balancing is completed. Reconfirm that the balancing screw is
tightened;
4.If not, repeat step 1.
1.Press and hold power button for 2 s and above, and when Rigiet is
noticeably stablized, release the power button to power on the Rigiet;
2.Press and hold power button for 2 s and above, and when Rigiet obviously
becomes powerless, release the power button to turn off the Rigiet.
! If the power button is pressed down for less than 2 s, Rigiet will stay at
mute mode. To recover it to normally operation from the mute mode, press
and hold power button for 1 s - 2 s. The mute mode is mainly used to
upgrade firmware, simply connect with the phone app, and view some
parameters of Rigiet.
4.7Rigiet status
Standard
Underslung
Horizontal
Portrait
4.6Turning on/off Rigiet
Right-bias
Balanced
Left-bias