Instructions / Assembly

DocaPole 30ft Light Bulb Changer Kit Assembly Instructions

1. Screw female threaded base of the Light Bulb Changer

attachment onto the male threaded metal tip of the

DocaPole extension pole. Tighten the secure-fit locking

screw located on the side of the Light Bulb Changer

2. To adjust extension pole length, raise thumb levers and

pull out pole segments to desired length, then lower

thumb levers to lock into place

3. Make sure the suction cup is clear of any dirt or dust by

wiping with a dry cloth

4. To remove a blown bulb, Press Light Bulb Changer onto

the bulb to create a secure suction (if you are having

trouble achieving suction you may need to slightly

moisten suction cup) and slowly spin the pole until bulb

is fully unscrewed

5. To release suction after installing new bulb, gently pull

the release string after the new bulb has been fully

screwed into the socket

PAGE 1
DocaPole 30ft Light Bulb Changer Kit Assembly Instructions 1. Screw female threaded base of the Light Bulb Changer attachment onto the male threaded metal tip of the DocaPole extension pole. Tighten the secure-fit locking screw located on the side of the Light Bulb Changer 2. To adjust extension pole length, raise thumb levers and pull out pole segments to desired length, then lower thumb levers to lock into place 3. Make sure the suction cup is clear of any dirt or dust by wiping with a dry cloth 4.