Installation Instructions

ManualsBrandsDocking Drawer ManualsNew CategoryBlade In-Drawer Outlet (2) 20 Amp AC Outlets

Blade Series

How to Install the Outlet

FOR CANADA

BLADE™ PART #:

1514-1x0

2012-1x0

Docking Drawer Blade Duo & Blade are

ETL Listed for use in Canada when installed

with an Interlock Box* that de-energizes the

outlet when the drawer starts to close.

(*sold separately)

For installations with optional Interlock Box,

see addendum installation manual before

starting the outlet installation.

Tools Needed:

• Jigsaw

• Drill

• Measuring Tape

• Screwdriver

• Square

• Pencil

• Cutout Template

Time Required - 30 min

Step 1 - Verify there is space available for the

in-drawer outlet behind the drawer box. The

Docking Drawer Blade Duo and Blade require

at least 2” of space behind the drawer box and

15” minimum drawer box width.

DOCKING DRAWER

BLADE

Step 2 - Remove the cutout template and

ip to the side that corresponds with your

product’s part number.

Step 4 - With a 1/2” drill bit, drill a hole in

each corner, being careful not to splinter the

wood on the inside of the drawer box. Using

one of the 1/2” holes, insert a jigsaw and then

make the required cutouts in the drawer box.

Step 3 - Locate the proper location for

the receptacle box cutout using our cutout

template. You can locate the proper location

from either the inside or backside of the

drawer box, making sure that the arms will

not interfere with the slides and that there is

enough material surrounding the receptacle

box to securely hold it in place.

BLADE DUO™ PART #:

1514-2xx

2012-2xx

• Failure to follow these instructions

can cause death or permanent injury.

Do not work on live electrical circuits!

Make absolutely certain power is o

before connecting the device!

• This product is for dry, indoor and

permanent installations only.

• Install the device in accordance with all

national and local electrical codes.

CAUTION – READ CAREFULLY

CUTOUT TEMPLATE

for Blade

BLADE PART #:

1514-1x0

2012-1x0

FOR ACCURACY SCALE PRINTER TO 100%

There are 4 methods to install the Blade Series

depending on your drawer box type. The

following instructions detail the installation

process for Shallow drawer box types. Need

more detail for the other options? Call us at

(925) 233-5598.

Downloadable Resources

For additional planning resources, visit

dockingdrawer.com/downloads

• DXF and STEP Files

• Mounting Diagrams

• Electrical Planning Guide

• Electrical Certications

Summary of content (2 pages)

PAGE 1
CAUTION – READ CAREFULLY Blade Series Installation Instructions • Failure to follow these instructions can cause death or permanent injury. Do not work on live electrical circuits! Make absolutely certain power is off before connecting the device! • This product is for dry, indoor and permanent installations only. Step 3 - Locate the proper location for the receptacle box cutout using our cutout template.
PAGE 2
Step 5 - Reinstall the drawer box and slide Step 7 - Install the the Docking Drawer Blade Series receptacle box through the cutout. Secure it with the 4 receptacle box mounting screws. cover plate. How to Operate the Outlet The 15 and 20 amp Blade Duo and Blade series in-drawer outlets include a 120˚F interlocking thermostat to protect against overheating inside the drawer. To reset, correct the source of over temperature and push the button in the center of the vents of the cover plate.