Installation Manual

12
Dockmate is a registered trademark from PPA-Electronics B.V.
Leuvensesteenweg 177 – BE-3191 Boortmeerbeek – Belgium
VAT BE 0891.773.260 – Tel. [phone] – Mob. [phone]
[e-mail] – www.dockmate.eu – [e-mail] – www.ppa-electronics.com
9. Connecting the TAKE COMMAND option
On the scheme above the option with two separate “TAKE COMMAND” buttons is
shown. When there is only one button,
leave “Take CMD 2” unconnected.
Some analogue gear shifts require only
one push on the boat’s “take command”
button. While others require two or more
pushes.
The required push/click hold time can
also vary from system to system.
If You have correctly connected the take
command cable but Dockmate is unable
to take command, please check the
“Take Command” settings.
In DockControl’s Dockmate Settings
window, go to the “General” tab.
There you will find the “Take Command”
section, where you can set the “Number
of clicks” and the “Click hold time”. Those
values need to be the same as or higher
than when you push the boat’s “take command” button.