Installation Manual

5
Dockmate is a registered trademark from PPA-Electronics B.V.
Leuvensesteenweg 177 – BE-3191 Boortmeerbeek – Belgium
VAT BE 0891.773.260 – Tel. [phone] – Mob. [phone]
[e-mail] – www.dockmate.eu – [e-mail] – www.ppa-electronics.com
1.1.2. TWIST Transmitter
Press the key for 1 second to turn on the transmitter.
The transmitter will be automatically switched off after 30 minutes of non use.
Alternatively the transmitter can be switched off by pressing 3 times the
button or holding it down for 3 sec.
After the transmitter is switched on, both LEDs will go white. Then the LINK
light will go dark and the STATUS LED will show one of following:
Battery fully charged More than 3.90V
Battery OK Between 3.45V and 3.90V
Battery Warning Between 3.30V and 3.45V
Battery Failed Less than 3.30V
Then it will go dark and the LINK light will show the communication status:
Communication
OK, actively
transmitting data
When moving the joystick or pressing a button
Communication
OK, standby
mode
When not moving the joystick or pressing any
button for more than 15s
Yellow / Green
Blinking
Receiver status warning.
For example CAN bus interface not in command
Purple / Green
Blinking
Receiver status error.
For example CAN bus interface not powered on
Communication
lost
When communication could not been
established or was interrupted. The transmitter
also beeps.