Installation Manual

8
Dockmate is a registered trademark from PPA-Electronics B.V.
Leuvensesteenweg 177 – BE-3191 Boortmeerbeek – Belgium
VAT BE 0891.773.260 – Tel. [phone] – Mob. [phone]
[e-mail] – www.dockmate.eu – [e-mail] – www.ppa-electronics.com
5. Connecting the Dockmate receiver to the
power
The Dockmate must be powered from the ship’s 12V or 24V installation. The
maximum voltage allowed on the Dockmate receiver is 28V.
It must be connected to a switch that is marked ‘Dockmate’, and/or to
the starting key.
On the picture the power connector inside the Dockmate is shown. The wires are
connected to the connector on the front panel shown below.
The two pins with white and brown wires are used for the ship’s ground, and the two
pins with yellow and green should be connected to the ship’s +12VDC or +24VDC.
Yellow is used to power the receiver.
Green is used to power the wireless charger.