Instruction manual

Before using the terminal
31
a Insert the dedicated AC adapter connector to the
wireless charger
b Insert the dedicated AC adapter's power plug into an
outlet
c Put the terminal on the wireless charger
･ Put the terminal with the mark down and align the
mark of the wireless charger to the battery pack.
･ For the information on the charging state, see " ■
Charge information".
･ The indicator LED of the terminal turns on in red
while charging, and turns off when charging is
complete.
d When charging is complete, remove the dedicated AC
adapter's power plug from the wall outlet
■ Charge information
You can check the charging status with the charge
information. Charge information descriptions are as
follows.
Turning on : Charging (Lights where detected)
Turning on → Turning off : Charging is complete
Flashing from top to bottom (or vice versa) sequentially
*
:
Detecting the position of the terminal/battery pack
Flashing rapidly (approx. 0.2 sec. interval) : Out of
charging area or problem in charging
Flashing a little slowly (at approx. 0.8 sec. interval)
*
:
Checking if the device is out of area
Flashing slowly (turn on for approx. 2 sec. → turn off for
approx. 1 sec.) : Waiting until the temperature drops and
becomes available to start charging
･ If the terminal/battery pack is not recognized, the charge
information does not turn on or off.
* If the charge information flashes rapidly or turns off before the
charging is complete, the terminal is not recognized. Remove the
terminal from the charging area to replace at the center of the
area.
✔ INFORMATION
･ Charge the battery putting the wireless charger on the
stable and flat place.
･ Always remove the AC adapter from the outlet when not
using the adapter for an extended period.
･ It is normal if the wireless charger may emit sound when
inserting the power plug into the outlet or putting or
removing the terminal/battery pack on or from the
wireless charger.
･ When charging the terminal, turn the vibrator off.
Vibration may move the terminal and the charging may
not finish or the terminal may fall.
･ Charging several terminals or battery packs at the same
time is not available.
･ If charging is not started, remove the terminal or battery
pack from the wireless charger. After approximately 2
seconds, put the terminal or battery pack on the mark.
･ If you use a carrying case for the terminal, remove it
before charging with the wireless charger.
To AC
100 V outlet
Power plug
Connector
Indicator LED
Dedicated
AC adapter
mark
Charge
information