Instruction manual

Appendix/Index 161
No caller ID is displayed/A notified caller ID is different from that of the caller/Functions that
use Phonebook data or caller ID notifications do not work.
 Even when a caller notifies the caller ID, it is not displayed on the FOMA terminal unless
notified from the network or network operator used. And, a notified caller ID may be different
from that of the caller by some networks or networks operators you use.
● Data management
Data transfer is not working.
 Are you using a USB hub? If you use a USB hub, data transfer may not work properly.
Data saved on a microSD card is not displayed.
 Remove the microSD card and insert it again.→ P.27
● Infrared data exchange
Cannot receive all contact data.
 Is there available space in FOMA terminal memory?
In case of space shortage while receiving data, data transfer is stopped at that point. The
received data is saved to the destination.
● Bluetooth function
FOMA terminal cannot find or be connected to a Bluetooth enabled device.
 Put the Bluetooth enabled device (commercial) on standby and register it on the FOMA
terminal. If you want to delete a registered device and register it again as a new device, you
must delete the registered device from both the Bluetooth enabled device (commercial) and
the FOMA terminal before you register it again.
Error message
"SIM card is PUK-locked."
 This message appears when you turn on the power while PIN1 code is locked. Tap
"Emergency call" and enter " 05 [PUK code] [new PIN code] [new PIN code]#" using
keypad. →P.78
 This message appears if you turn on the power or attempt to perform an operation related to
the UIM while the PIN unblocking key is locked. Contact a docomo shop.→ P.77