Specifications

Chapter 5
5 - 2
Figure 5.1 The removable fan and filter tray
You can replace the filter without replacing the fan tray. This requires you to
remove the fan tray and replace the old filter with a new one.
To replace the filter only
1. Start by opening the front panel of the BIG-IP system running in
standby mode.
2. The fan tray is held into the chassis using a knurled fastener. Loosen
the knurled fastener by turning it counter-clockwise.
3. Pull the old fan tray and filter out of the system.
4. Slide the old filter out of the fan tray filter slot. Slide the new filter
into the filter slot.
5. Replace the fan tray. The tray is automatically turned on by sliding
the tray completely into the chassis.
6. Tighten the knurled fastener into place by turning it clockwise.
7. Close the front panel of the unit.