User's Manual

If the indicator light blinks rapidly for two seconds and

then turns to a constant light, continue with (Program-

ming( steps 6-8 tocomplete theprogramming of a rolling

code equipped device (most commonly a garage door

opener).

6. At the garage door opener receiver (motor-head unit)

in the garage, locate the 9learn9 or 9smart9 button. This

can usually be found where the hanging antenna wire is

attached to the motor-head unit.

7. Firmly press and release the 9learn9 or 9smart9 button.

(The name and color of the button may vary by manu-

facturer.)

NOTE: There are 30 seconds in which to initiate step

eight.

8. Return to the vehicle and firmly press, hold for two

seconds and release the programmed HomeLink button.

Repeat the (press/hold/release( sequence a second time,

and, depending on the brand of the garage door opener

(or other rolling code equipped device), repeat this

sequence a third time to complete the programming.

HomeLink should now activate your rolling code

equipped device.

NOTE: To program the remaining two HomeLink but-

tons, begin with 9Programming9 step two. Do not repeat

step one. For questions or comments, please contact

HomeLink at www.homelink.com or 1-800-355-3515.

Canadian Programming/Gate Programming

Canadian radio-frequency laws require transmitter sig-

nals to 9time-out9 (or quit) after several seconds of

transmission which may not be long enough for

HomeLink to pick up the signal during programming.

Similar to this Canadian law, someU.S.gateoperators are

designed to 9time-out9 in the same manner.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 123