Owner`s manual

10. Remove the Dodge center cap using a jack tool from inside the aluminum road wheel
and snap on the protective plastic plate.
NOTE:
The plastic plate will prevent the road wheel
from being scratched when sliding it under
the vehicle.
11. Stand the wheel up against the bumper
with the plastic plate facing you.
12. Slide the cable end, spring and metal tube through the wheel and plastic plate. Rotate
the stamping on the cable and push it through the wheel and plastic plate. Snap the
stamping into place.
13. Slide the road wheel on the ground using
the protective plate until it is directly
under the winch and between the rear
bumper and exhaust system heat
shields. Raise the tire by turning the lug
wrench on the winch extension clock-
wise until it clicks/skips three times to
make sure the cable is tight.
NOTE:
Double check to ensure the tire is snug against the underbody of the vehicle. Damage to the
winch cable may result if the vehicle is driven with the tire loose.
WHAT TO DO IN EMERGENCIES
139