Owner`s manual

To send a text message:
a. Press the Uconnect® Phone button,
b. Wait for the beep,
c. Say “Text.”
d. Uconnect® will prompt you “Say the phone number, or full name and phone type of
the contact you want to send a message to.”
e. Wait for the beep and say a contact that is in your phonebook, or a mobile phone
number that you would like to send the message to.
f.
Uconnect® will prompt you “Please say the message that you would like to send” (If you
do not hear this prompt, you may not have an active subscription with Uconnect®
Access).
g. Wait for the beep, and then dictate any message up to 140 characters. If you exceed
140 characters, you will hear the following prompt: “Message was too long; your
message will be truncated.”
h. Uconnect® will then repeat the message back to you.
i. Uconnect® will prompt you: “ To add to your message, say ‘Continue’; To delete the
current message and start over, say ‘Star t Over’; to send the current message, say
‘Send’; to hear the message again, say ‘Repeat’.
j.
If you are happy with your message and would like to send it, wait for the beep and say
‘Send’.
k. Uconnect® will then say “Sending your message.”
Sample Commands for Voice Text Reply and Voice Texting
Example Command Action
“Text John Smith”
Send a message to specific contact in ad-
dress book
“Text 123 - 456 - 7890”
Send 123 - 456 - 7890 a message from your
phonebook
“Show messages”
See recent text messages listed by number
on Uconnect® screen
“Listen to/view (message number four, for
example)”
Hear messages or read it on Uconnect®
screen
“Reply” Send a voice text reply to a current message
“Forward text/message to ‘John Smith”
Forward current text to specific contact in
address book
“Forward text/message to ‘123 - 456 - 7890”
Forward current text to specific phone number
ELECTRONICS
60